Early detection of "empty" in the greenhouse

The empty space, that is, the plant grows too strong and does not sit on the fruit, is a problem that often occurs in the planting of autumn sweet pepper.

The high temperature and high humidity environment is the root cause of the empty pepper. Slow seedling period and sweet pepper results in the early stage, high temperature and high humidity environment are easy to cause sweet peppers long, so that the first door pepper is difficult to sit; and the first fruit can not sit, even more drama plant length, resulting in malignant Loop so that it forms an "empty". In the case of partial application of nitrogen fertilizer, the "empty" of sweet pepper is more serious.

In this regard, the author believes that to prevent the "empty" of sweet peppers, it is necessary to highlight an "early" word, which must be grasped from the slow seedlings at the time of planting.

First, after planting, it is necessary to close the greenhouse for 2-3 days (to ensure that the shed temperature does not exceed 35 °C), keep warm and moisturize, and promote slow seedling; second, after slowing down the seedling, it is necessary to release the wind in time to reduce the humidity inside the shed. In the initial stage, the shed temperature of 28-30 °C is maintained, and then the shed temperature standard is gradually lowered, and the flowering and fruiting period is maintained at 20-25 °C. Such sweet pepper plants grow short and strong, the internodes are short, and there are many fruit sets. The third is to strengthen water and fertilizer management. The sweet pepper leaves are small, the water transpiration is not large, and the watering should not be too much when planting. After the seedlings are harvested, it is generally not easy to water, otherwise it is easy to cause falling flowers and fruits. When the first layer of fruit begins to harvest, it is necessary to strengthen watering and fertilization. According to the rule of sweet pepper and high potassium, topdressing is necessary to increase the application of potassium fertilizer to benefit the high yield of sweet pepper and improve fruit quality.

Total 1 | <First <Prev 1 Next> Last> |
share to:

Sensor Tri-proof Light

There are two types of sensors for Tri-proof Light; one is infrared induction, and the other is microwave induction.

Both types of sensors can control the following values through the remote control shown in the picture below:

controller

1. Can set the light value. If the value of the ambient light meets the light value you set, it will not turn on even if there is a moving signal. When the ambient light does not meet the set value, the light will turn on.

2. The waiting time can be set. That is, how long the light stays low after the person leaves the sensing area.

3. Set the delay time, that is, how long the light stays in the full-on state after the person leaves the sensing area.

4. Set the preset brightness: you can set the full brightness and low brightness.

5. Set the detection range.

6. Remote control distance: You can set the distance range of the remote control sensor.


The function:

1.Switch function (stand-by period is set to "0s")

4


2.Two-stage dimming function (stand-by period is set to "+∞")

5

3.Three-stage dimming function (stand-by period is set to "0s/30s/10min/ +∞")

6


In addition, the LED Tri-proof Light can be waterproof, dustproof and anti-corrosion. Therefore, the Sensor Tri-Proof Light is especially suitable for parking lots.




Ip66 Lighting,Waterproof Tube Light,Ip66 Light Sensor,Ip66 Led Lights

SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com