If the formula of the sole of the safety shoe is relatively hard, it is more effective for the support of the toe cap. Another factor to consider is that the sole should be kept in line with the edge of the toe cap when designing, and the sole should have a tooth pattern. This is because the spacing between the bottoms of the soles does not provide good support, so it is possible to avoid overlapping the edges of the safety shoe's steel toe and the bottom of the sole. Another design feature of the sole that may affect the safety of the steel toe cap of the safety shoe is that the total thickness of the sole gradually decreases toward the direction of the toe, which increases the toe of the toe. Conversely, this affects the protective performance of the safety shoe steel toe cap, which is tilted forward when subjected to impact or impact, thus causing the front shell of the toe cap to be lower than the trailing edge of the toe cap. Because most safety shoe steel toe caps are designed to transmit impact and pressure through its front shell, if its front shell is depressed below the trailing edge of the toe cap, its force transfer mechanism will not function effectively, the toe cap The trailing edge will suffer severe deformation. There is also a feature of the sole component that also affects the protective ability of the safety shoe steel toe cap, which is the longitudinal section of the upper surface that is cut along the width of the sole and viewed from the longitudinal and transverse sections. The upper material recessed into the sole here increases the gap in the middle of the safety shoe toe cap, so the amount of deformation of the toe cap is greater when subjected to possible injury. DIN125 DIN9021 Flat Washer,DIN9021 Flat Washer,Flat Washer DIN9021 Jiangsu Minglu Stainless steel Co.,ltd , https://www.minglufastener.com
The anti-smashing performance of the safety shoe steel toe cap may be affected by various factors. According to the principle of protective space in our daily work, not only the steel toe cap of the safety shoe must have sufficient strength, but also the sole should be able to form the necessary supporting strength immediately under the pleat of the toe cap under pressure or impact, so as to be impacted. The force can be effectively transferred to the ground without causing other parts such as the steel toe cap above the safety sole to sink into the sole after being stressed.