Inner Support Fabric Air Duct,Air Duct Material,Fabric Air Duct,Air Conditioning System Jiangsu Buna Technology Development Co. , Ltd. , https://www.bunaduct.com
Common solutions for the network connection of scenic gate control panel
The common problems and solutions of the ticket gate server of the scenic gate control panel are not connected to the network:
1. Failure to connect to the network due to the failure of the router or switch connected to the network
Solution:
1) Check the router power supply and network cable connector problems. Ordinary routers or switches work for a long time, which will cause the route to hang up. For this situation, you can power off the route for 1-5 minutes, and then power on again.
2) The crystal head of the network cable is loose, or someone inadvertently touches the network cable to make the connection impossible. For this situation, plug the network cable back and forth.
3) The network is aging, causing a short circuit. This situation often occurs when some companies use network cables produced by informal manufacturers. After more than a year, due to the use of recycled and regenerated materials made of skin materials, it is easy to cause a short circuit from the inside. And it is not easy to check. If the old network cable is gently pulled, the sheath of the copper wire breaks into segments, and the network cable is directly replaced in this case.
4) The quality of the crystal head is not good, making false contact. In this case, the test can be used when crimping. However, after a period of poor contact or the network cable is unavailable, the crystal head crimping is repeated for this situation.
5) The router short-circuits the network cable, that is, the two ends of the network cable are connected to the router or switch. This situation is rare. For this situation, unplug the shorted network cable.
2. The server address on the gate control board is wrong
Solution: Just write the correct address of the gate control board server (or the server deployed by the enterprise).
3. The address change of the cloud server (or the server deployed by the local enterprise) is not the same as the service address of the gate control board
Solution: The correct address of the synchronization server.
4. The gate control board server does not implement the corresponding interface as required