The company research and development of double servo precision automatia pipe cutting machine, suitable for all kinds of pipe material, and the soild pipe cutting, especially suitable for the mass production of the enterprise, the machine has high production efficiency, good rigity,high precision(make sure the error within 5 wire), one feed can cut more piece.The machine adopts PLC control, the most advanced double servo positioning system,hydraulic clamping feeding. Make up the previous machine of rust, bending the disadvantages of insufficient material, eliminate waste.
The machine has warning for borken blades/no material/remain material in insufficient, high production efficiency,and can achieve more than one machine management.The pipe cutting machine adopts the cross roller guide rail, with good rigidity, small rolling friction, long life, high precision etc.Vertical and horizontal drag plate with double feed servo system, a fast response, stable feeding. The Tube pipe cutting machine use special bearings steel cutter chip, easy and quick to change cutter.The mahcine can be divided into three side Chamfer Pipe Cutting Machine and od turning Steel Pipe Cutting Machine.
Pipe Cutting Machine,Taper Roller Bearing Machine,Bearing Ring Machine,Pipe Parting Machine Shaoxing Sunfong Intelligent Equipment Inc. , https://www.zjsxsunfong.com
During the discussion, everyone agreed that in 2008, the China Knife Association, in conjunction with industry needs, insisted on serving members and carried out a number of meaningful work. The China Knife Association has actively carried out advanced tool application technology training, organized member units to participate in important exhibitions and industry technical exchange meetings, and has improved the level of advanced processing and application technology for members, broadly expanded business channels, and broadened the members' horizons. The meeting reviewed the relevant work of the Board of Directors proposed by the Secretariat in 2009 and proposed amendments.
The deputy directors and vice-chairmen exchanged views on the various units and their views on the current situation, reflecting the problems and development opportunities in the fields of production, learning, research and use. Everyone believes that the China Knife Association has a wealth of information and collaboration resources and should be fully utilized. The meeting held that in the face of the current economic situation, everyone should pay more attention to independent innovation and structural upgrading, vigorously promote informationization, and strengthen the service awareness of modern manufacturing. It is necessary to issue an initiative to the whole industry to make green manufacturing, sustainable development and harmonious win-win as the theme of the next step of the China Knife Association.
China Knife Association 2009 Chairman's Working Conference Held in Beijing
On the occasion of the CIMT 2009 held in Beijing, the 2009 China Tool Association's 2009 Chairman's Working Conference was held on April 5th at the Beijing Institute of Technology International Exchange Center. The main content of the meeting was to summarize the work of the China Knife Association in 2008 and to study the work arrangement in 2009. Xing Min, Chairman of the China Knife Association, Wang Luzhou, Executive Vice President, and Vice Presidents and Secretary General attended the meeting. The meeting was chaired by Chairman Xing Min, and the Secretary General of Shang Hongjun reported on the work of the China Knife Association in 2008.