The bathroom is the key project of home decoration, and it is also a place where decoration is prone to problems. If there is a slight carelessness, it may cause serious problems of water leakage and water accumulation. Many owners do not understand bathroom waterproofing practices. So there are several ways to waterproof bathroom ? Follow Xiaobian to find out! There are several practices for bathroom waterproofing : 1, bathroom waterproof there are several practices - brush the first time waterproof coating Make sure that the ground is dry before applying the waterproof coating for the first time. The waterproof coating must be completely covered. There must be no omission. The bond with the ground layer must be firm and there must be no cracks or bubbles. When brushing height, thickness to meet product requirements. 2, there are several ways bathroom waterproof - brush the second time waterproof coating. Brush the second time the waterproof coating must wait the first time the paint is dry enough to brush. If the interval is too short, the first pass of the paint is not yet dry, and the effect of waterproofing will be greatly reduced. 3, bathroom waterproof there are several ways - shop protection layer. To avoid damaging the waterproof layer in the later period of construction, it is necessary to apply a protective layer on the surface of the waterproof coating. The protective layer should completely cover the waterproof layer and the surface should not have cracks, bubbles or the like. 4, bathroom waterproof there are several practices - closed water test. The minimum time for the closed water test is 24 hours or so and the water level at the highest point on the ground is higher than 2 cm. Observe the phenomenon of leakage. If there is leakage, waterproofing is needed again. Waterproof construction precautions : 1, the ground needs leveling Make sure the floor of the bathroom is stable before doing waterproofing. If the floor tiles of the bathroom need to be replaced, the original floor tiles shall be cut to level the ground with cement mortar, and then the waterproof treatment shall be performed. This will prevent leakage of the waterproof coating due to uneven thickness. 2, seams need to brush in place Bathroom joints are the most prone to problems and must be painted in place when applying waterproof coatings. Such as: seams between the walls of the ground, the seam between the upper and lower water pipes and the ground. 3, wall treatment The waterproofness of the bathroom wall is also very important, generally about 30 cm waterproof layer, so that it can prevent the accumulation of water infiltration walls. If the wall is a light wall, waterproof paint must be applied to the entire wall. 4, closed water experiment After the waterproof construction of the toilet is completed, all the water outlets of the toilet are blocked and the sandbags at the entrance are tightly closed. Then, 20 cm high water is poured into the toilet to perform a water-sealing experiment. After 24 hours, see the leakage. If the bathroom has a shower, it is also necessary to do a watering test on the wall, so as not to stick the wall, the wall seeps into another room. Take a rubber hose to drain the water to flush the wall. The wall is watered for about 5 minutes. Then check the other side of the wall for seepage. Concluding Remarks: The above is the relevant content of the bathroom waterproofing method introduced for everyone. I hope that I can help a friend in need. If you need to learn more about the later stage, please pay attention to the information on this site. 2 tier Cooling Rack,3 tier Cooling Rack,Foldable Cooling Rack,Creative Cooling Rack Shenzhen Lanejoy Technology Co.,LTD , http://www.grill-grid.com
